VE3OY
TORONTO, CANADA
GRID: FN03GQ
43.7000° N - 79.4000° W
 
 

Installing the BHI NEDSP1061-KBD
in the Kenwood TS-850Sat

WARNING

Performing this modification is
DONE AT YOUR OWN RISK

Neither I, nor BHI Limited can be held
responsible for any damage caused to your radio.


- Remove both top and bottom covers.
- Mount the DSP unit in the area normally used for the VOICE module (under the flip cover).
- Tap into the red wire (connector on the back wall for auto-tuner) for 12 volts.
- Mount the supplied ground wire bundle connector to the screw on the shield casing.
- Route the audio wires (red, blue and shield) down the left rear of the chasis to the bottom.
- Locate and remove C164 from the IF board (bottom of radio).
- Install and solder the RED wire where the positive lead of C164 was.
- Install and solder the BLUE wire where the negative lead of C164 was.
- Install and solder the shield wire to a convenient ground point on the board.
- Adjust the audio levels according to the instructions from BHI.

That's it! Enjoy listening with reduced/eliminated hiss and static!





Video of BHI-DSP in a TS-850SAT (#1)
Video of BHI-DSP in a TS-850SAT (#2)
Video of BHI-DSP in a TS-850SAT (#3)
Video of BHI-DSP in a TS-850SAT (#4)
Video of BHI-DSP in a TS-440SAT (#1)
Video of BHI-DSP in a TS-440SAT (#2)
Video of BHI-DSP in a TS-440SAT (#3)
Video of BHI-DSP in a TS-440SAT (#4)




COPYRIGHT © 2020 VE3OY.COM | All rights reserved
Contents of these pages may NOT be downloaded, displayed, copied
or used elsewhere without the express written consent of VE3OY.
Corporate icons and logos are copyrighted by their respective owners.

This website displays best when viewed
with one of these web browsers:

Total Visits
,
Total Unique 
,
Visitors last month 
Visitors this month 
Visitors this week 
Visitors yesterday 
Visitors today